Connecting an Unmanaged Pull Target

If you have added an Unmanaged Pull Target (by selecting Other as the device type), then you will need to configure the Zixi-enabled device in order to connect it to ZEN Master. The UI structure varies for different Zixi-enabled devices, however the following settings should be configured to connect to ZEN Master.

For a Dynamic Target, you can use the same Configuration data for each Receiver (or decoder) that you would like to connect to the Target. Each Receiver must have a unique ID.

To connect a Zixi-enabled device:

In ZEN Master, in the main navigation, click Targets.
Select the relevant Target from the list of Targets.
In the Info pane on the right side of the screen, go to the Manual Configuration section.

This tab contains specific configuration settings for the selected target. Use the values shown for the following parameters to configure the Zixi Enabled device:

Parameter	Description
Host	The IP address/URL of the ZEN Master host.
Port	The port that has been configured in ZEN Master.
Stream ID	The stream name.
Password	The access password that has been configured in ZEN Master.

ZEN Master User Guide

Connecting an Unmanaged Pull Target

Analytics

Related content