MediaConnect Feeder Output with Network Bonding

To Add Network Bonding to a Feeder Output:

1. In the Outputs page of Zixi MediaConnect Feeder, click + New Output in the menu bar.
   The New Output window is displayed:
   
   

   Open

   

2. Enter the unique Output
   
   

   Open

   

   want to configure on the MediaConnect Feeder.

3. In the Output Parameters section, enter the parameters as described in the Adding a Push Output section.  

4. Click the Bond Links checkbox.
   The bonded link section is displayed:

5. In the boded link section, click the + button. 
   A new row of destination fields is displayed:
   
   

1. In the Port field, type the destination port number of the AWS MediaConnect to which you want to stream. Default: 2088 

2. In the IP field, do one of the following:

   • If you want to set a specific IP address, select the IP address of the Zixi MediaConnect Feeder that you want to use.

   • If you want to use all available IPs, select ALL.

3. In the Max Bitrate field, do one of the following:

   • If you want to limit the bitrate that will be used in this link, enter the limit value in Kbps.

   • If you DO NOT want to limit the bitrate, leave the default value - Unlimited. 

4. In the Backup field, do one of the following:

   • If you want to use this link only if there is not enough bandwidth in the other links, select the Backup checkbox.

   • If you want to use this link in parallel to other links, DO NOT select the Backup checkbox.

5. Click OK.

6. Repeat the steps above to add additional links.