Page Comparison

To add network bonding Add Network Bonding to a Feeder Output:

1. On the In the Outputs page page of Zixi Feeder, click Image Removed   on the upper- right end corner of the screen. 
   The New Output window click + New Output in the menu bar.
   The New Output window is displayed:
   Image RemovedImage Added
2. Enter the unique Name that you want to configure on the Feeder.
3. Select Push to Broadcaster as the Type of output.
4. In the Properties section, enter the parameters as described in the Creating a Push to Broadcaster Output procedure. 
5. Select Click the Bonded Link checkbox.  
   The bonded link section is displayed:
   Image Removed Image Added
6. In the boded link section, click the + button.  
   The Bonded Link Destination dialog opensA new row of destination fields is displayed:
   Image RemovedImage Added
7. In the Host IP field, type the IP address do one of the destination Zixi Broadcaster. 
8. In the Port field, type the destination port number of the Zixi Broadcaster to which you want to stream. Default: 2088    
9. In the NIC field, select the NIC in following:
   • If you want to set a specific IP address select the IP address of the Zixi Feeder that you want to use
   to stream. 
   • If you want to use all available IPs, select ALL.
10. In the Bitrate Limit field, do one of the following:
    if
    • If you want to limit the bitrate that will be used in this link, enter the limit value in Kbps.
     
    • if
    • If you DO NOT want to limit the bitrate, leave the default value -
    "0"
    • Unlimited.
      
11. In the Backup field, do one of the following:
    • If you want to use this link only if there is not enough bandwidth in the other links, select the Backup
    checkbox
    • .
     
    • If you want to use this link in parallel to other links, DO NOT select the Backup
    checkbox
    • .
     
12. Click OK.
13. Repeat the steps above to add additional links. Click OK to save the Feeder Output.