To Create a UDP Output:
- On the Outputs screen of ZiXi Feeder, click
on the upper- right end corner of the screen.
The New output window is displayed:
- Type in the unique identifier for this output in the Name field.
- From the Type drop-down list, select UDP Output.
- From the Input Name drop-down list, select the desired input stream.
- If you have created a filter, select the desired Program and Filter.
- Specify the Properties (see table below for additional parameters).
- In the Host field, specify the IP address of the stream destination.
- In the Port field, specify the port of the destination.
- In the NIC field, select the network card from which the stream will be transmitted.
- Click OK.
The new UDP Output with its settings is created and now appears on the Outputs screen.
...
| Parameter | Description |
|---|---|
Name | Specifies the unique name of the stream. |
Type | Select UDP Output. |
| Input |
Input Name | Choose the input name from the drop-down list, whichconsists of all the previously configured inputs on the Feeder |
Program | If you have created a filter, you can select the relevant program |
Filter | If you have created a filter, you can select the relevant filter |
| Properties |
Host | Specifies the IP address of the stream destination. |
Port | Specifies the port of the stream destination. |
Smoothing | Enables transmission of the output at the correct rate. Required when the receiving device is sensitive and can’t lock on to the stream (in such a case, the recommended latency is 100 - 1000 ms). |
NIC | Specifies the Network card used. |
TTL | Specifies the network Time-to-Live parameter |
...