...
| Parameter | Description |
|---|---|
Stream ID | Specifies the unique identifier for this output stream. |
Input Stream | Specifies the input stream that is associated with this output. |
Show in Matrix | Enables stream to be shown in Matrix. |
| Output Parameters | |
Host | Specifies the destination address of this output. |
Port | Specifies the port to listen on. |
TTL | Specifies the time-to-live (TTL). Used mainly to limit the range (or “scope”) of a multicast transmission. Leaving it as blank uses the default value specified by the operating system. |
Smoothing [mms] | Enables transmission of the output at the correct rate. Required when the receiving device is sensitive and can’t lock on to the stream (in such a case, the recommended latency is 100 - 1000 ms). |
RTP | Enables the Real-time Transport Protocol |
SMPTE 2022 FEC: | Disables the FEC or specifies the type of FEC matrix to D1/ D2 |
Bind to IP | Specifies the local IP address to use, or any one which can be sourced from any active NIC. Select the local IP from the drop-down menu. |
Local Port | Specify from which local port to source the stream, if desired (instead of randomly chosen by the operating system). |
Don’t Fragment | Select this option if you do not want to fragment IP packets in a stream. |
Decryption type | If the stream has been excryptedencrypted, you can decrypt through the output by selecting this checkbox and specifying the type of ecryption that was used. Only if the stream has not been encrypted, select None (default). Important Notice: if the stream has been encrypted you must decrypted in the output. |
| Decryption key | If the decryption type includes a key, enter the key to decrypt the stream during output. |
Remuxing | Enables remuxing to CBR (used for professional IRDs). |
Remux to bitrate [kbps]: | Specifies the CBR bitrate to target for a remuxed stream. |
...