To Create a UDP Output:

In the ZiXi Broadcaster Outputs page, click . The New output window is displayed.
Type in the unique identifier for this output in the Output Name.
Select an Input Stream to be made available on this output from the drop-down list.
Select the Show in Matrix check box to display this stream in the Matrix (see Using the Matrix). Default: Selected.
Select UDP.
Specify the Output parameters (see Output Stream Parameters Table).
In the Host field, specify the IP address of the stream destination.
In the Port field, specify the port of the destination.
If you want to remux the stream to CBR (used for professional IRDs) in order to avoid bandwidth waste, select Remuxing and configure the respective parameters (see Output Stream Parameters Table).
Click OK.

The new UDP Output with its settings is created and now appears on the Outputs screen.

Output Stream Parameters Table

Parameter	Description
Stream ID	Specifies the unique identifier for this output stream.
Input Stream	Specifies the input stream that is associated with this output.
Show in Matrix	Enables stream to be shown in Matrix.
Output Parameters
Host	Specifies the destination address of this output.
Port	Specifies the port to listen on.
TTL	Specifies the time-to-live (TTL). Used mainly to limit the range (or “scope”) of a multicast transmission. Leaving it as blank uses the default value specified by the operating system.
Smoothing [mms]	Enables transmission of the output at the correct rate. Required when the receiving device is sensitive and can’t lock on to the stream (in such a case, the recommended latency is 100 - 1000 ms).
RTP	Enables the Real-time Transport Protocol
SMPTE 2022 FEC:	Disables the FEC or specifies the type of FEC matrix to D1/ D2
Bind to IP	Specifies the local IP address to use, or any one which can be sourced from any active NIC. Select the local IP from the drop-down menu.
Local Port	Specify from which local port to source the stream, if desired (instead of randomly chosen by the operating system).
Don’t Fragment	Select this option if you do not want to fragment IP packets in a stream.
Decryption type	If the stream has been encrypted, you can decrypt through the output by selecting this checkbox and specifying the type of ecryption that was used. Only if the stream has not been encrypted, select None (default). Important Notice: if the stream has been encrypted you must decrypted in the output.
Decryption key	If the decryption type includes a key, enter the key to decrypt the stream during output.
Remuxing	Enables remuxing to CBR (used for professional IRDs).
Remux to bitrate [kbps]:	Specifies the CBR bitrate to target for a remuxed stream.

Browser not supported