Zixi Broadcaster enables monitoring and control via SNMP. The monitoring system can receive SNMP Trap messages from Zixi Broadcaster as well as access monitored objects with read-only and read-write access privileges (objects and their access permissions are defined in the MIB). Zixi Broadcaster supports SNMPv1, SNMPv2, and SNMPv3. Before using SNMP you need to ensure that SNMP is enabled in your Zixi Broadcaster license, run a script, as described below, and configure the SNMP settings in the Settings >SNMP screen.
To Activate SNMP:
Run the script file ./install_snmp.sh, located in the Broadcaster folder, where Zixi Broadcaster was installed. The events on the log screen are deleted.
Note
Running the script may cause Zixi Broadcaster to restart.
To Save the Log as a File:
- In the Event Log screen, click Save on the upper right-hand corner.
A .cvs file is created and saved to the local destination.
To Refresh the Screen:
- In the Event Log screen, click Refresh on the upper right-hand corner.
The data on the screen is updated.