Typically a Push Stream is transmitted from a ZiXi Feeder. In this case, the stream is initiated by the ZiXi Feeder, while the ZiXi Broadcaster remains in “listening mode” until the stream is initiated.
To Add a Push Stream:
- Click the Inputs tab at the top of the ZiXi Broadcaster administrative screen.
- Click New Input on the upper right hand side of the screen. The Add a new input stream window is displayed.
Enter the unique Stream I.D. for the Broadcaster.
Note this must be identical (case sensitive) to the stream name configured in the ZiXi Feeder.
- Select the maximum concurrent connections to this stream from the Max. Outputs drop-down list. Default: Unlimited.
- Select the Show in Matrix check box to display this stream in the Matrix (see Using the Matrix on page 45). Default: Selected.
- Select Push for this input stream.
- Specify the Stream Parameters (see additional parameters).
- If you want to Enable time shift, select this checkbox (see table below for additional parameters). The stream will be recorded and broadcasted after the specified delay. The time shift feature is typically used to broadcast a live event across time zones (due to the time differences between locations).
- If you want to Transmit as multicast, select this checkbox (see table below for additional parameters).
- If you want to record the stream, you can configure the Recording Parameters (see table below for additional parameters).
- Click OK.
- The “Input added” message appears on the top of the screen. The Push Stream from the ZiXi Feeder is added to the ZiXi Broadcaster and now appears in the list of input streams available in the ZiXi Broadcaster input UI.
Parameter | Description |
|---|---|
| Stream Parameters | |
| Password (Optional) | If desired, enter a password string to use for authentication (must be identical to the string configured on the Feeder) |
| Latency [ms] | Specify the maximal latency that will override the latency that was defined on the Feeder (in ms). Default: Remote configuration (i.e. use the latency was set on the feeder). (See Latency Considerations) |
| Point to point only | Selecting this checkbox transmits the stream directly (point-to-point) from the Feeder to the Receiver, while only delivering messaging to the Broadcaster. In case there is a problem with the P2P connection, it will re-route the transmission through the ZiXi Broadcaster. |
| Disable P2P Fallback | Selecting this checkbox will allow only P2P (disabling the option to re-route traffic though the ZiXi Broadcaster) |
| ID of high priority source | Setting the ID of the source that will be granted a higher priority during connection. A feeder with this ID will disconnect other existing sources. |
| Enable time shift | |
| Maximum delay [hh:mm:ss] | Specify the time of the delayed transmission of this stream. Maximum: 24 hours. |
| Transmit as multicast | Selecting this checkbox enables the transmission of this stream’s outputs as multicast. A ZiXi receiver that will pull the stream will receive it in multicast. By default ZiXi Broadcaster is configured to allow transparent fallback to unicast if it is out of the LAN. |
| Multicast Only | Selecting this checkbox will force the transmission of this stream only in multicast. |
| Recording parameters | |
| Max recorded file duration [hours] | Specifies the maximum time allotted for recording a video stream. Default: 2 hours |
| Keep recorded files for [hours] | Specifies the maximum time for storing the recording. Default: 0 hours |
| Decrypt stream | *Automatic encryption does not require manual settings. |
| Decryption type | |
| Decryption key |