Page Comparison

...

1. In the Zixi Broadcaster Navigation menu, click the Inputs tab.
2. In the Menu bar, click New Input. The Add a new input stream window is displayed.
   
   
   

3. Enter the unique Stream I.D.

4. Select the maximum concurrent connections to this stream from the Max. Outputs drop-down list. Default: Unlimited.
5. Select the Show in Matrix check box to display this stream in the Matrix (see Using the Matrix). Default: Selected.
6. Select Delayed for the input stream.
7. Specify the Stream Parameters (see Input Streams Stream Parameters Table).
8. If you want to Enable time shift, select this checkbox (see Input Streams Stream Parameters Table).
9. If you want to Transmit as multicast, select this checkbox (see Input Streams Stream Parameters Table).
10. Click OK.

11. The “Input added” message appears on the top of the screen. The Delayed Stream is added to the Zixi Broadcaster and now appears in the list of streams available in the  Zixi Broadcaster inputs UI.

    Input Stream Parameters Table

    Show input in matrix.Enables multicasts (unless in which case it will receive as unicast). You can also force Multicast only outputs. Requires

    Parameter	Description
    Stream ID	Specify the unique identifier for this stream.
    Max Outputs	Specify the maximum number of allowed outputs. Default: Unlimited.
    Show in Matrix
    Stream parameters
    Source	Select one of the input streams that were configured to enable "time shift".
    Delay	Specify the delay period relative to the original stream.
    Enable time shift	Select this checkbox to record the stream content and broadcast it after the specified delay.
    Maximum delay [hh:mm:ss] (for time shift enabled)	Specify the maximum time delay of this input.
    Transmit as multicast	Select this checkbox to enable the transmission of this stream’s outputs as	multicast. A Zixi receiver that will pull the stream will receive it in multicast	. By default Zixi Broadcaster is configured to allow transparent fallback to unicast if it is out of the LAN	. Requires enabling Multicast Pull in the Settings.
    Multicast-Only (for multicast enabled)	If desired, specify multicast only outputs.

...