Page Comparison

Output Parameters

Name

Specify the unique name of the stream.

Primary source

Multiple sources are designated for redundancy and can be used by default according to a certain hierarchy. Specify the unique Stream ID that the Zixi Receiver expects. Must be identical to the one on the Broadcaster. The drop-down list consists of all those previously configured inputs on the Receiver. Select the desired input stream that will be the primary source.

Host

Specify the IP address of the stream destination.

Port

Specify the ports to listen to for the output streams.

NIC

Specify the Network card used on the Receiver.

TTL

Specify the time-to-live (TTL). Used to limit the range (or “scope”) of a multicast transmission.

PCR Smoothing [ms]

Specify the PCR smoothing latency. This enables transmission of the output at the correct rate. This is required when the receiving device is sensitive and can’t lock on to the stream (in such a case, the recommended latency is 100 - 1000 ms).

RTP

Click the checkbox to enable the Real-time Transport Protocol.

SMPTE 2022 FEC

Specify the FEC (Forward Error Correction) mode. Options are: Disable (default), 1D and 2D. Disables the FEC or specifies the type of FEC matrix to D1/ D2.

Remux

Click the checkbox to enable remuxing to CBR (used for professional IRDs) thus avoiding bandwidth waste.

Bitrate [kbps]

Specify the CBR bitrate to target for a remuxed stream.