...
| Parameter | Description | |
|---|---|---|
| Output Parameters | ||
Host | Specify the destination IP address or URL. | |
Port | Specify the target UDP port. | |
TTL | Specify the time-to-live (TTL). Used mainly to limit the range (or “scope”) of a multicast transmission. Leaving it as blank uses the default value specified by the operating system. | |
Smoothing [mms] | Enables transmission of the output at the correct rate. Required when the receiving device is sensitive and can’t lock on to the stream (in such a case, the recommended latency is 100 - 1000 ms). | |
RTP | Enables Enables use of the Real-time Transport Protocol. | |
SMPTE 2022 FEC: | Disables the FEC or specifies the type of FEC matrix to D1/ D2. | |
Bind to IP | Specify the local IP address to use, or any one which can be sourced from any active NIC. Select the local IP from the drop-down menu. | |
Local Port | Specify from which local port to source the stream, if desired (instead of randomly chosen by the operating system). | |
Don’t Fragment | Select this option if you do not want to fragment IP packets in a stream. | |
Decryption type | If the stream has been encrypted, you can decrypt through the output by selecting this checkbox and specifying the type of ecryption that was used. Select Automatic to decrypt a stream that has been encrypted using Automatic encryption. Only if the stream has not been encrypted, select None (default). Important Notice: if the stream has been encrypted you must decrypt it in the output. | |
| Decryption key | If the decryption type includes a key, enter the key to decrypt the stream during output. | |
Remuxing | Enables remuxing to Select this checkbox to enable remuxing from VBR MPEG-TS to MPEG-TS CBR (used for professional IRDs). | |
Remux to bitrate [kbps]: | Specify the CBR bitrate to target for a remuxed stream. |
...