Page Comparison

Redundant streams can be delivered over multiple Network Interface Cards (NICs) in either a PUSH or PULL configuration.

Source Configuration

To configure the primary source node (e.g. Zixi Receiver):

1. On the Inputs page of the primary Zixi Receiver, click    on the upper- right end corner of the screen.
2. In the Output Name field, type a new name for the output. 
3. In the Input Stream field, select the relevant input stream.
4. Select the Push option.
5. In the Output Parameters section, under Links, enter the details of the target, including:
   The target Host - Specify the destination Broadcaster name or IP address to which you are pushing the stream.
   The Port number - Specify the ports to listen on for Push streams. Default - 2088
   Target IP -  
6. Set the desired Max Latency in milliseconds.
7. Click OK to create the primary output,

To configure the secondary source node (e.g. Zixi Feeder):

1. On the Outputs page of secondary Zixi Feeder, click    on the upper- right end corner of the screen.. 
2. In the Output Name field, type the same name used for the primary output.
3. In the Output Parameters section, under Links, enter the same details of the primary target, including:
   The target Host - Specify the destination Broadcaster name or IP address to which you are pushing the stream (secondary target).
   The Port number - Specify the ports to listen on for Push streams. Default - 2088
   Target IP -  
4. Set the desired Max Latency in milliseconds

5. Click OK.

Target Configuration

To configure the target node (e.g. Zixi Broadcaster/Receiver):

1. Click the Inputs tab at the top of the Zixi Broadcaster administrative screen
2. Click New Input on the upper right hand side of the screen.
3. Select the Push option.
4. Create an input at the primary target, ensuring the “Stream ID” matches that of the primary and secondary sources output.
5. Configure additional parameters as required. 
6. Click OK.

Cost Considerations

This topology duplicates the network link. Allocation of the expected maximum bitrate with head room is advised on each network path.

Latency Considerations

Primary Connection loss         = 

Retry cycle                              =

Connection to secondary        =

Total recovery Time                =