Page Comparison

Displays the current bitrate of the input stream.

Displays the amount of time the stream has been active.

Displays the number of reconnection attempts.

Remuxing resets can occur when remuxing to CBR (i.e value of ‘Remux to bitrate’ field is set). In this case, the value is not high enough to remux the video+audio+other PIDs data. A possible solution is to increase value of the ‘Remux to bitrate’ parameter.

The Smoothing feature uses a buffer to time packets according to the stream's clock. This is useful when there are bursts in the rate in which the stream arrives. The smoothing drops indicator indicates that the stream is too "bursty".

Displays the Round Trip Time (RTT) from the source (in milliseconds).

Displays the current Jitter, measured in milliseconds.

Displays the stream latency configured on the source.

Displays the total number of packets that have been transmitted.

Displays the current number of packets per second.

Displays current percentage of the packets that were dropped on route from the source.

Displays the total number of packets dropped between the source and the Broadcaster since the beginning of the stream.

Displays the number of dropped packets that have been recovered since the beginning of the stream.

Displays the number of non-recovered packets.

Displays the number of FEC packets transmitted.

Displays the number of FEC packets recovered.

Displays the number of requests for retransmission of dropped packets made with ARQ.

Displays the number of dropped packets recovered via ARQ.

Displays the number of duplicate recovery packets received via ARQ.

The number of packets lost due to buffer overflow.
Note: Overflow is usually the result of the Max Bitrate being too low.