Page Comparison

Host

Specify the destination IP address or URL.

Port

Specify the target UDP port.

TTL

Specify the time-to-live (TTL). Used mainly to limit the range (or “scope”) of a multicast transmission. Leaving it as blank uses the default value specified by the operating system.

Smoothing [mms]

Enables transmission of the output at the correct rate. Required when the receiving device is sensitive and can’t lock on to the stream (in such a case, the recommended latency is 100 - 1000 ms).

RTP

Enables use of the Real-time Transport Protocol.

SMPTE 2022 FEC:

Disables the FEC or specifies the type of FEC matrix to D1/ D2.

In the SMPTE-2022 FEC standard, 1-D and 2-D parity codes are systematic FEC codes of decent complexity that provide protection against bursty or random losses. To enable SMPTE-2022 FEC (Forward Error Correction) select one of the following parity options from the drop-down menu:

• 1D (single dimension FEC) - SMPTE-2022 1D can fix a problem in ONE packet per row. This means that the number of rows specified should consider the packet loss rate- the shorter the row, the more error resilience can be achieved on the expense of bitrate level. However, longer rows increase the delay that the FEC will add. It is recommended to select this option when the packet loss is sporadic.
  The stream will occupy the source port and two ports above it (e.g. if the source port is 8988, it will occupy 8990)
• 2D - SMPTE-2022 2D uses a table of packets, which includes rows and columns. This option is more error resilient, but it increases the delay by (row*column) packets and increases the bitrate with R+C packets per each table of R*C packets. It is recommended to select this option when packet loss is bursty.
  The stream it will occupy four ports above (e.g. if the source port is 8988, it will occupy 8992).

Bind to IP

Select from the drop-down list the local IP address to be used for this Output, OR select Any to enable any IP to be used.

Local Port

Specify from which local port to source the stream, if desired (instead of randomly chosen by the operating system).

Decryption type

If the stream has been encrypted, you can decrypt through the output by selecting this checkbox and specifying the type of ecryption that was used.

Select Automatic to decrypt a stream that has been encrypted using Automatic encryption.

Only if the stream has not been encrypted, select None (default).

Important Notice: if the stream has been encrypted you must decrypt it in the output.