Page Comparison

...

1. In the ZiXi Broadcaster administrative screen, click the Inputs tab.
2. Click New Input. The Add a new input stream window is displayed.Image Removed

The Add new input screen includes the following properties:

Stream ID: Enter the unique Stream I.D. for the Broadcaster.

Max Outputs: Select  the maximum concurrent connections to this stream from the Max. Outputs  drop-down list. Default: Unlimited.

Show in Matrix: Select the Show in Matrix check box to display this stream in the Matrix (see Using the Matrix on page 45). Default: Selected.

Radial buttons, include:

• Push:
• Pull:
• UDP:
• Delayed:
• File:
• RTMP:
• RTSP:

Stream Parameters

...

Parameter

...

Selecting this checkbox transmits the stream directly (point-to-point) from the Feeder to the Receiver, while only delivering messaging to the Broadcaster.

...

Selecting this checkbox enables the transmission of this stream’s outputs as multicast. A ZiXi receiver that will pull the stream will receive it in multicast. By default ZiXi Broadcaster is configured to allow transparent fallback to unicast if it is out of the LAN.

...

Push Stream

1. Select Push for this input stream.
2. Specify the Stream Parameters (see table below for additional parameters).
3. If you want to Enable time shift, select this checkbox (see table below for additional parameters). The stream will be recorded and broadcasted after the specified delay. The time shift feature is typically used to broadcast a live event across time zones (due to the time differences between locations).   
4. If you want to Transmit as multicast, select this checkbox (see table below for additional parameters).
5. If you want to record the stream, you can configure the Recording Parameters (see table below for additional parameters).
6. Click OK.
7. The “Input added” message appears on the top of the screen. The Push Stream from the ZiXi Feeder is added to the ZiXi Broadcaster and now appears in the list of input streams available in the  ZiXi Broadcaster input UI.